Faculty, staff, and students can access remote computers (e.g., desktops at work that you do not have physical access to) from their local device (e.g., a computer at home that you are using) using Remote Desktop technology.
| Note |
|---|
ITS is turning on two-factor authentication (DUO) for the Remote Desktop Gateway to enhance security. We will implement this change for ITS on Thursday, December 10 and for the rest of the University in 2021. |
Instructional Guides
For assistance choosing a guide, view our recommendations.
| Child pages (Children Display) | ||
|---|---|---|
|
...
| Tip |
|---|
Most UConn computing resources do not require a remote desktop connection. If you are working off-campus and have a university-issued computer, you most likely do not need Remote Desktop. There are only a few computing resources that require it. |
Important reminders
The computer that you want to connect to remotely MUSTremotely:
- Remain
Must remain on.
- Remain
Must remain connected to the internet via Ethernet (hard-wired
ethernet to the internet).
Cannot go into hibernation or sleep mode.
If you have been able to connect to a computer remotely, but have lost access, there is an unfortunate likelihood that the machine has disconnected and needs to be checked in person.
...
the computer is probably powered off or is offline. ITS is unable to go to your on-campus office to turn it on for you.
Limitations
If you are using a personal computer, this service is still possible and you may follow these guides as they are written. However, ITS cannot offer direct support for personal machines in the event of problems that may arise. Please also be aware
ofof security recommendations and best practices
forfor using a personal device for work.
- Pulse Secure VPN/Direct Access is not necessary to use this service. If you are using a personal device, you may not have either option.
The Cisco AnyConnect VPN is not needed for Remote Desktop. Simply follow the guides below, paying specific attention to setting up the remote gateway on your local machine.
- If the remote machine is running OS X (Mac) or Linux, you will not be able to remotely connect using supported software unless you also have a corresponding Mac/Linux local machine. That means it is possible to connect to your work PC from a Mac at home, but it is not possible to connect to your work Mac from a PC at home. This can be resolved using third-party software, such as TeamViewer. However, ITS does not support the installation or troubleshooting of third-party software.
Gaining Access
If you are an admin on your own machine, as is standard for machines managed by ITS, you will not have issues remotely connecting. If you are not an admin,follow the articles as written, paying specific attention to the sections where you allow remote users to connect.
...
Use the following table to quickly find the guides that best fit what you need.
...
You cannot remotely connect to a computer running macOS or Linux.
Only the device admin can connect by default. Other users will need to be added manually.
Get started
First, you need to set up your remote (on-campus) computer to allow incoming remote desktop connection requests. You can do so here: Enable Incoming Remote Desktop Connections
Then, you can set up your local (off-campus) computer to connect to your remote desktop: Connecting to a Remote Computer