Versions Compared

Old Version 4

changes.mady.by.user Daniel Facchinetti

Saved on

compared with

New Version Current

changes.mady.by.user Daniel Facchinetti

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Note

When you are finished with your session please make sure to sign out of the room computer and press the “System OFF” button on the Lightboard touch panel. Please also turn off the microphone(s) and place them back in their charger.

Lightboard start-up and use:

  1. The Lightboard is primarily controlled by the touch-screen panel located on the left-hand side of the board. The initial screen will appear as the following:

    Lightboard UCONN-20240209-161812.png

  2. Tap the screen to proceed to begin using the system.

  3. Once pass the initial screen, the following options will appear:

    Lightboard Source-20240209-161812.png

  4. The center of the screen asks to select a source which will be captured during the recording. The options include:

    1. Computer: Reflects the screen of the stationary computer already in the room.

    2. Laptop HDMI: Allows a user to connect their own computer. The cable is located on the stand directly next to the control screen and Document Camera. (USB-C to HDMI adapter is available in the EdTech office, Rowe 422.)

    3. Document Camera: Also located on the stand next to the Lightboard. Must be powered on to be able to use.

    4. No Source: No input will be used and the system will display the Lightboard and presenter only.

...

Info

For additional help on using the Lightboard, please contact the Educational Technology Office down the hall in Rowe 422, or via email at edtech@uconn.edu or (860) 486-5052.

Note

For audiovisual or technological technical issues, please contact ITS as 860-486-4357, then press #1. Contact information can also be accessed via the Help button on the control screen.