ITS has changed the wireless service in UConn residence halls to improve coverage and performance. All buildings, with the exception of Werth Tower
...
and Northwood Apartments, have new equipment installed
...
.
New Wireless Access Points
...
| Note |
|---|
If your room has a new access point installed, the ports on the old jack may be blocked. This signals that the jack is no longer in use. |
...
| Tip |
|---|
For the best wireless performance, do not obstruct the access point; do not put any belongings or furniture in front of it or do anything that might damage it. |
Plugging in for Wired Service
To access the wired service, you need to plug an Ethernet cable into the port on the new wireless access point and into the port on your device. The port on the new access point is located along the bottom (shown below).
| Note |
|---|
For residents of Werth Tower, Mansfield Apartments, and Northwood Apartments, you can connect to the wired network by plugging one end of your Ethernet cable into the wall jack and the other end into the Ethernet port on your computer. ITS has installed access points in every other room in the North Campus complex. If you are in a room that does not have the new wireless access point, you should plug your Ethernet cable into the wall jack. |
| Info |
|---|
| Info |
For information about wired network connections in residence halls, see Wired Network in Residence Halls. |
Related Articles
| Filter by label (Content by label) | ||||||||
|---|---|---|---|---|---|---|---|---|
|
...
|
| Page Properties | ||
|---|---|---|
| ||
|